Gallery Pellet Stove Parts

Printer Friendly Tell a Friend
 
image
RC1902
Remote Control to operate manual mode, temperature, on/off and hold/unhold- for model S1902 and HP22.
 
image
CB1902
 Software based control board mounted at rear top of pellet stove - for model S1902 and
HP-22.
 
image
PB1902 
 
This power board is located at the  left side of the pellet stove behind the rear left panel - for model S1902 and HP-22.
image
FS1902
 Replacement fuse
for electronic circuit  board.


 
 
image
RC1902
 
Ribbon cable that connect the program board with the power board - for model S1902 and HP-22.


 
image
EXM1902
 
Exhaust motor - complete -  can be easily removed by undoing 4 wing nuts, located at the rear bottom of the stove - for model S1902 and HP-22.
image
 COF1902
Squall cage design convection motor with a very quite operation is located at the center / rear of the fire box, can be removed very quickly, the speed is controlled by computer for maximum efficiency - for model S1902 and HP-22.

 
image
AUM1902
 A new and unique Auger motor design to give more reliability and strength with  a very quite operation, located at rear of pellet stove just bellow hopper - for model
S1902 and HP-22.
 
image
MC1902
 Motor capacitor which is clipped onto frame close to auger motor. Gives more stability and torque to auger motor - for model S1902 and HP-22.


image
IG1902
 
Igniter with cable and easy connector. Used to ignite the pellets to allow for automatic operation for model S1902 and HP-22.

 
image
TC1902
 Thermostat located on the exhaust motor housing to let the computer know that a fire has been established. Closes at 120F - for model S1902 and HP-22.

 
image
TH1902
 High limit thermostat located at the rear left side of body, lets the computer know that a too high of a temperature has been reached - for model S1902 and HP-22.

image
PS1902
 Pressure switch located at rear left side where the power board is mounted, lets computer know that exhaust fan is working and that all doors are closed and the body is sealed - if any of these conditions do not exist the pressure switch will let computer know not to feed any pellets - for model S1902 and HP-22.

 
image
RB1902
 Decorative rear board which provides a barrier between hopper/components and burn area, located behind burn pot on back wall- for model S1902 and
HP-22.

 
image
SB1902
 Decorative side boards which provides a barrier between hopper/components and burn area, come singly- for model S1902 and HP-22.




image

image

Contact us
Atlanta America
CIL Forwarding
8 Santa Fe Way #803
Cranbury, NJ 08837
Tel.18003854717
Fax.9082423883
office@atlanta-wholesale.com


Innovation
Innovated Products For A Better World
The Best Products - The Best Prices.


Gallery
Pellet Stove
Gallery
Hearth Pads
Gallery
Pellet Stove Parts
Gallery
Propane Refrigerator
Slideshow